Page 1
Tel : +64 9 525 7570 Tel : +65 6344 2378 must be given to the owner / operator of this equipment. ACT Distributor Tel : +61 2 6280 6476 www.waterco.com Waterco Limited ABN 62 002 070 733 (W33850) 07/2010...
Waterco Fulflo Pressure Pump IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS WARNING RISK OF ELECTRIC SHOCK DANGER Connect only to a grounding type receptacle protected by a ground-fault circuit-interrupter (GFCI) or a Residual Current Device (RCD) with a rated residual current not exceeding 30mA.
Page 3
INTRODUCTION ------------------------------------------------------ 01 APPLICATION SUITABILITY ----------------------------------------- 01 The Waterco Fulflo Pressure Pump will function correctly with or without a pressure pack. If no pressure pack is used, the pump will run whenever water is demanded from the unit. If a pressure ASSEMBLY &...
Page 4
I pg 03 Waterco Fulflo Pressure Pump Assembling the Waterco Fulflo Pressure Pump Unit 3. If you have purchased a pressure pack; a. Wrap 3-4 turns of Teflon tape onto the male threaded end of the Pressure Pack and screw on the Tee fitting.
Suction Port: 25mm (1 inch) female BSP. Delivery Port: 25mm (1 inch) female BSP. The Waterco Fulflo Pressure Pump Pressure System can be installed in as follow; Pipe runs in excess of 10 metres should use a minimum of 40mm (1 ½ inch) pipe.
If the Waterco Limited pump is within the stated warranty period and you experience faults always contact your supplier or the nearest Waterco Limited branch for advice. Failure to do this may void To check the air pressure, proceed as follows: the warranty.
Need help?
Do you have a question about the W33850 and is the answer not in the manual?
Questions and answers