Advertisement
3.2.4 Remove the servo control board (See figure 7)
(1) Disconnect the FFC wire from connector CN102, CN103,
CN104,
CN105
on the servo control board.
(2) Remove the two screws D attaching the servo control
board.
(3) Hooks d is removed, and the servo control board is re-
moved.
3.2.5 Remove the loading motor (See figure 8, figure 9)
• Prior to performing the following procedure, remove the top
cover, tray.
(1) Remove the solder part e soldered on the switch board.
(2) A belt is removed.
(3) Remove the two screws E attaching the loading motor.
Loading
motor
Part e
Fig.8
E
Belt
Fig.9
Switch board
(No.YD091)1-13
Advertisement
