Pre-Installation; Included Components; Tools Required For Installation; Key Installation Facts - Humidex CCC-103E Installation & Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Included Components

Before installing your Humidex, make sure that you have the right model and accessories. The

following items should be included in the accessory box. If parts are missing, contact our customer

service at US 1-888-533-1348, Can. 1-800-416-9111.

1x Owner's Manual

1x Warranty Card

1x 4" x 12" Toe Space Grill

1x Exhaust Vent 6"

1x Checklist

Additional grilles for replenishment air and interior rooms not included.

Tools Required for Installation

Electric reciprocal or hole saw 6¼"

Drill with a ¼" concrete bit

Phillips or Robinson Screw Driver

Measuring Tape

Hammer

Pencil

For concrete, cinderblock or brick installation, use a hammer drill with chiseling ability ½" x 16"

long and a chisel bit 1" thick.

Key Installation Facts

1) Unit must be installed at floor level – approximately 3" off the floor.

2) Replenishment air has to flow from upstairs into the basement or crawlspace. Open doors

that can be closed are not a substitute for a properly installed vent.

3) Unit should be installed as far away as possible from the source of replenishment air.

4) Outside duct must be no less than 6" and dedicated for the Humidex unit only.

5) Maximum circulation is required to draw in air from all parts of the crawlspace.

6) Unit should not be installed within 8 feet of combustion appliance.

IMPORTANT – What Not to Do

1) DO NOT install the unit more than approx. 3 inches off the floor.

2) DO NOT make more than one turn with the duct and the ductwork should not be longer than 3

feet in total, unless rigid ducting is used - see 'ducting" following.

3) DO NOT crush the vinyl Pipe.

4) DO NOT install the unit next to a replenishment air supply.

Humidex