Projector Status Lights - Epson PowerLite 600p Product Information

EPSON PowerLite 600p/800p/810p Projectors
Adjusting the Image Shape
If the projected image isn't square or has a "keystone" shape,
do one or more of the following:
❏ If your image looks like
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely. If you still can't get a square image, press the left or
Keystone
right button on the projector's control panel.
❏ If your image looks like
Keystone
bottom button to correct the shape of the image.
After correction, your image will be slightly smaller.
You can also perform electronic keystone correction using the
projector's Setting menu.
Switching Between Picture Sources
If your projector is connected to more than one computer
and/or video source, you can use the buttons on the control
panel (or remote control) to switch between the different
sources.
On the control panel, press the
switch between computer sources and component video. Press
Video
the button to switch between standard (composite)
video and S-Video sources.
On the remote control:
❏ Press the
Comp2/YCbCr
component video source connected to the Computer 2/
Component Video port on the projector.
❏ Press the
Comp1
button to select a computer connected to
Computer 1
the DVI port on the projector.
❏ Press the
Video
button to select a standard composite video
source.
❏ Press the
S-Video
button to select an S-Video source.
After you select a source, the screen goes dark for a moment
before the image appears.
6 - EPSON PowerLite 600p/800p/810p Projectors
or , you've placed the
or , press the top or
Computer/YCbCr
button to
button to select a computer or

Projector Status Lights

The lights on top of the projector indicate the projector's
operating status.
power light
Light Status
Does not
come on
Green
Flashing
green
Orange
Flashing
orange
Flashing red
Red
Flashing
orange
Flashing red
8/01
temperature
lamp light
light
Description and action
Make sure the power cord is securely
connected at both the power outlet and
projector.
The projector is operating normally.
The projector is warming up. Wait for the
image to appear.
The projector is in sleep mode. You can
unplug it to turn it off, or press the Power
button to turn it on.
The projector is cooling down. Wait for the
light to stop flashing before unplugging the
projector or turning it back on.
Power is cut off because of an internal
problem. Disconnect the power cord and
contact EPSON for help.
The lamp is burned out and must be replaced.
The lamp is almost burned out. This is a good
time to replace it.
There is a problem with the lamp, power
supply, fan, or circuit. If necessary, replace the
lamp.