Advertisement
Contents
Connections
Audyssey
®
Set Audyssey MultEQ
XT32, Audyssey Dynamic EQ
®
Dynamic Volume
and Audyssey LFC™. These can be selected after
®
Audyssey
®
Setup has been performed.
For additional information on Audyssey technology, please see
"Explanation of terms" (v p. 305).
0 "MultEQ
®
XT32", "Dynamic EQ", "Reference Level Offset", "Dynamic Volume",
"Audyssey LFC™" and "Containment Amount" settings are stored for each input
source.
0 When the sound mode is in the "Direct" or "Pure Direct" mode, "MultEQ
"Dynamic EQ", "Dynamic Volume" and "Audyssey LFC™" settings cannot be
configured.
0 When the sound mode is in "DTS Virtual:X" or sound mode that have "+Virtual:X"
in the sound mode name, "Dynamic EQ", "Dynamic Volume" and "Audyssey
LFC™" settings cannot be configured.
0 This item cannot be selected when a DTS:X format with a sampling frequency of
over 48 kHz is input.
0 This cannot be set when the input mode is set to "7.1CH IN".
Front panel
Display
Playback
Settings
o MultEQ
MultEQ
, Audyssey
®
characteristics of the listening area based on Audyssey
measurement results. Selection is done from three types of
compensation curves. We recommend the "Reference" setting.
Reference
(Default):
L/R Bypass:
®
XT32",
Flat:
Off:
0 When using headphones, "MultEQ
179
Rear panel
Tips
®
XT32
®
XT32 compensates for both time and frequency
Selects the default calibrated setting with
a slight roll off at high frequencies, which
is optimized for movies.
Selects the reference setting, but
bypasses MultEQ
and right speakers.
Selects the calibrated setting which is
optimized for small rooms where your
listening position is closer to the
speakers.
Do not use "MultEQ
®
XT32" is automatically set to "Off".
Remote
Index
Appendix
®
Setup
®
XT32 on the front left
XT32".
®
Advertisement
