Installation
1. Check the location.
■
Avoid the following locations for installation.
• Uneven or unstable locations
(on blocks, timbers, a table with wheels, etc.)
• Locations with a possibility of freezing
2. Attach the bottom cover.
Preparation: Set a cardboard, etc. and lay the
washing machine on it, avoiding
product damage and deformation.
(Face the front side down.)
1
Insert the bottom cover along
the guides, and set 3 holes to
the corresponding
projections.
Projection
Hole
2
Fix with screws.
(6 locations for right, left and top)
3. Attach the external drain water hose.
1
Connect.
2
Slide the
hose band
in the arrow
direction.
● Slide all the way
until it stops.
14
Hole
Guide
Screw hole
Insert all the way.
Hose band
HOT COLD
Water tap
adaptor
Water supply
hose
Bottom cover
External drain
water hose
NOTE
● Do not put the
hose tip under
water.
● Do not raise the
hose higher than
10 cm above the
floor.
● Do not extend the
overall length to
more than 3 m.
Water supply
valve screw
Power plug
10 cm or
less
3 m or less