Chapter 4: Filtration Instructions; Preparing The Built-In Filtration System For Use - Frymaster FPGL30 Installation, Operation And Maintenance Manual

CHAPTER 4: FILTRATION INSTRUCTIONS

The on-site supervisor is responsible for ensuring that operators are made aware of
the inherent hazards of operating a hot oil filtering system, particularly the aspects
of oil filtration, draining and cleaning procedures.
4.1

Preparing the Built-In Filtration System for Use

The FootPrint Pro filtration system allows the oil in one frypot to be safely and efficiently filtered
while the other frypots in a battery remain in operation. The FootPrint Pro filtration system is
available in three different configurations:
•
Filter Paper – includes crumb tray, large hold-down ring, and metal filter screen.
•
Filter Pad – includes crumb tray, small hold-down ring, and metal filter screen.
•
Magnasol Filter – includes crumb tray and Magnasol filter assembly.
Section 4.1.1 covers preparation of the Filter Paper and Filter Pad configurations for use. Refer to
Section 4.1.2 for instructions on preparing the Magnasol Filter configuration for use. Operation of
all three configurations is the same and is covered in section 4.3. Disassembly and reassembly of the
Magnasol filter is covered in section 4.4.
4.1.1 Preparing the Built-In Filtration System for Use with Filter Paper or Filter Pad
The FootPrint Pro filtration system allows the oil in one frypot to be safely and efficiently filtered
while the other frypots in a battery remain in operation. The FootPrint Pro filtration system uses a
filter paper configuration which includes a crumb tray, large hold-down ring, and metal filter screen.
1. Pull the filter pan out from the cabinet and
remove the crumb tray, hold-down ring, filter
paper and filter screen (see Figure1). Clean
all components with a solution of detergent
and hot water then dry thoroughly.
The pan cover must not be removed except
for cleaning, interior access, or to allow a
shortening disposal unit (SDU) built before
January 2004 to be positioned under the
drain. Disposal instructions are on page 1-6
in the controller manual.
™
OCF30 SERIES GAS FRYERS
WARNING
4-1
Figure 1