Getting Started - VTech Sort & Recycle Ride-On Truck Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located under
the Mode Selector. Use a screwdriver
to loosen the screw, then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5
5
5