Inalto Classique IFLW60 User Manual page 14

Troubleshooting
WARNING
Only authorised technicians can carry out repairs.
Before contacting our customer service team, please refer to the table below to see if your fault can be fixed by
yourself. Should a service technician visit be arranged and its found there are no faults with the appliance, a call out
charge will apply.
PROBLEM
Washing Machine
won't start-up
Door won't open
Heating fault
Water is leaking
Water is overflowing from the
base of the machine
Display isn't lighting up
Detergent residues remain in
the detergent drawer
Washing results aren't
to expectations
Washing machine is making an
abnormal noise or vibrating
Note: If the above steps don't resolve your issue or you cannot resolve the fault by yourself:
• Press the "On/Off" button.
• Switch off the appliance at the power outlet and remove the plug.
• Call our customer service team.
SOLUTION
• Check that the mains plug is inserted and switched on at the power point.
• Check that the door is closed securely.
• Check that the relevant fuse hasn't blown.
• Check that the On/Off button has been pressed.
• Check that the water supply tap has been opened.
• The machine's safety protection is working. Disconnect the power and reconnect the power.
• The NTC is damaged and/or the heating pipe is aging. You should be able to wash the clothes
normally however without the water heating. Please contact our customer service team.
• The drainage waste pipe may be blocked.
• Check and fasten all water connection pipes.
• Inlet or Outlet hoses may be damaged. Please check.
• Check that the inlet pipes are connected firmly at the rear of the machine.
• Check that the outlet hose hasn't been damaged.
• Check that the power isn't disconnected.
• PC board may have issues. Please contact our customer service team.
• Ensure you are using a correct amount of detergent.
• Follow the cleaning steps to remove any damp residual detergent from the drawer.
• Ensure you are using a sufficient amount of detergent.
• Ensure the correct quantity of clothes are being used depending on the wash program selected.
• Ensure you are using the correct wash program to suit the clothing and level of dirtiness.
• Try using an alternative detergent.
• Ensure the washing machine is level.
• Ensure that all transportation bolts have been removed.
• Ensure the appliance has been installed on a solid and level floor.
• Ensure that all legs are making contact with the floor and adjust as required.
• Follow the Drain Pump cleaning procedure and ensure there are no foreign objects.
User Manual 14