Assembly - Craftsman 580.768350 Operator's Manual

Your cleaning system requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
• Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
• Remove hose reel box, fillers, and parts box
shipped with your cleaning system.
• Roll the cleaning system out the open end of the
carton.
• Raise guide handle, secure in place.
Lift the handle to upright
position and slide the locking
caps into place
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
• Main unit — cleaning system with wheels, chemical
tanks, guide handle
• Hose reel components
• High pressure hose
• Parts box (which includes items listed below)
Spray gun
Nozzle extension with adjustable nozzle
Engine oil
Three-pack of chemical concentrates
Owner's manual
Nozzle cleaning kit
"O"–ring kit
Tank labels
Quick connect fitting

ASSEMBLY

Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 7. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR CLEANING
SYSTEM
Your Craftsman high pressure cleaning system was
mostly assembled at the factory. However, you will
need to perform these tasks before you can operate
your cleaning system:
• Attach hose reel.
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to the spray gun and
pump.
• Connect water supply to pump.
Assembling Hose Reel
IMPORTANT: You must take the hose off the reel
when operating your high pressure washer. The reel is
for storage purposes only.
• Attach the handle to the reel with locknuts,
flatwashers, and bolts as shown.
• Secure the hose reel to the left side upright, (from
behind the unit), with locknuts, flatwashers, and
bolts. See page 7 for reel mounting location.
M6 Bolts
4
M6 Flatwashers
M6 Flatwashers
M8 Flatwashers
M8 Locknuts
Handle
M6 Locknuts
M8 Bolts