Advertisement
Getting Started - cont'd
fig. 2
fig. 3
2 Use the lavender loop on the side of
the micro-fiber cleaning pad to place
around the all-purpose mop head.
Then attach the quick fasteners on
the top of the pocket to secure in
place. (fig. 2)
3 Snap the mop head into the base to
secure it. (fig. 3)
4 Turn the water tank cap counter
clockwise and remove from the tank.
(fig. 4)
Use the filling flask and pour water
into the tank. Please don't overfill.
Replace the cap on the water tank.
(fig. 5)
4
TOLL FREE: 1-800-798-7398
fig. 4
fig. 5
IMPORTANT: Don't use on unsealed
wood or unglazed ceramic floors.
On surfaces that have been treated
with wax or some no wax floors,
the sheen may be removed by
the heat and steam action. It is
always recommended to test an
isolated area of the surface to be
cleaned before proceeding. We
recommend that you check the use
and care instructions from the floor
manufacturer.
Using Your Steam Mop
IMPORTANT: Make sure you don't
use the mop without attaching a
micro-fiber cleaning pad and adding
water to the tank first. When you are
using the mop for the first time, it
might take longer than the normal 30
seconds to start steaming.
fig. 6
IMPORTANT: Your Steam Mop needs
water to make steam! Never use your
steam mop without water in the tank.
S weep or vacuum your floors prior to
cleaning with your Steam Mop.
V isit www.sharkclean.com for other
great quick cleaning products to
complement your Steam Mop, such
as the Shark
Navigator
®
(model NV350).
fig. 7
1 P ull and twist the quick release cord
holder to unwrap the power cord
completely. Plug into a 120-volt
electrical outlet. (fig. 6)
2 The ON/STANDBY switch will
flash blue. If the light does not turn
on, reference the troubleshooting
section on page 12. (fig. 7)
www.sharkclean.com
English
5
Advertisement
