Advertisement
1.tube cleaning 2 language 3 time setting 4 EMS energy 5 skin type 6RF open and energy
adjust7 speed 8 account 9 ID card 10 open/close 11 EMS switch
2.14
Click the start button to use two disposable medical cotton swabs to
tighten the skin. The handle is attached to the skin vertically and from the
bottom to the top according to the texture of the skin. (Note: Before operation,
press the handle to adjust the dose button"+", to see if the instrument is
normally out of the liquid, and then operate. When you are operating, look at
whether solution bottle is vertical, and change the direction of the handle at
any time.)
2.15 Wipe the medical repairing gel. After 20 minutes, clean and dry.
2.16 Use Medical wound repairing mask, after 20mins ,unloading mask and
use raw salt water gauze block clean.
2.17 After treatment, clean the instrument pipeline, first start the instrument to
drain the residual product in the pipeline, then put the warm water of about 40
degrees into the solution bottle, install the device to the handle, click the
screen to let the instrument automatically clean the pipe. After the warm water
bottle is cleaned, then click finish.
3.Precautions after use
3.1 In treatment part, It's a normal phenomenon that appears some reddish and some small particles will
.
it will disappear within a week
3.2 The skin can't touch the water within 6 hours after the operation. B B cream can be used on
Advertisement
