Advertisement
4. Installing the Main Tube: The main tube is installed on the front rail using the M8 x 16 hex head bolts with
attached washers. Position the tube on the horizontal portion of the front rail with the rulers facing up and the
12 inch ruler on the left side. The powder coated surfaces of the tube and rail can be slick, so be careful that
the tube does not fall off the rail. Align the holes in the rail with the holes in the bottom of the tube. Thread the
M8 x 16 hex head bolts through the rail and into the threaded holes in the bottom of the tube. See Fig. 7. Leave
the bolts finger tight.
Fig. 7
The holes in the bottom of the front rail are oversized to allow the position of the tube on the rail to be adjusted.
To set the tube in the correct position, first pull the tube away from the cast-iron table as far as possible. Next,
place your fence down on the tube with the fence glide bracket resting on the upper rear edge of the tube.
Position the fence so that it is near the left end of the tube and the front glide pads are in contact with the rear
surface of the main tube. See Figs. 8a and 8b.
rear glide pad
front glide pad
Fig. 8a
Fig. 8b
page 5
Advertisement
