Advertisement
Next, install the M8 x 45 socket head bolt and D-washer through the hole in the center of the left side of the
extension table. The bolt should also extend through the center hole in the right extension wing. Make sure the
flat edge of the D-washer is facing upward. See Fig. 6. Install an M8 washer and an M8 lock nut on the end of
the bolt and hand tighten.
Fig. 6
If you left the rear rail slightly loose, tighten it now. If necessary, pull up or push down on the extension wings
before tightening as described above.
Once both rails are installed securely, adjust the position of the extension table so that its top surface is level
and flush with the top surface of the cast iron extension wing. Fully tighten the nuts to lock the extension table
in place. If necessary, put upward or downward pressure on the left edge of the extension table to make it flush
with the extension wing, and then tighten the M8 x 45 socket head bolt that passes through the D-washer.
Finally, adjust the position of the foot on the bottom of the support leg to ensure the leg is in solid contact with
the ground.
page 4
Advertisement
