Advertisement
Installation
To install the rails, extension table, and fence you will need the following tools:
5 mm hex driver and 6 mm hex key (included)
13 mm and 17 mm wrenches (or adjustable wrench)
Phillips head screwdriver
1. Installing the Front Rail: The first step in installing the fence is to attach the long angle iron rails to the table.
Please see pages 10 and 12 for exploded views of the rails and extension tables. The rails are shipped in
the long cardboard box packaged with the main tube. The front rail is the larger of the two and includes 5
countersunk holes that are used to mount the rail to the front of the table. To mount the front rail, position the
rail along the front of the table with the cut-outs at the top of the rail centered on the miter gauge slots in the
table. Thread three M8 x 25 countersunk socket head bolts into the tapped holes in the front of the main table.
See Fig. 1. Tighten the bolts using the 5 mm hex driver.
Use longer bolts
for mounting rail to
extension wings.
Next, mount the front rail to the cast iron extension wings using two M8 x 35 countersunk socket head bolts,
two M8 washers, two M8 lock washers and two M8 hex nuts. Position the bolts through the front rail and the
extension table, then install the washer, lock washer and nut (in that order) on the end of the bolt. The holes in
the extension wings are not tapped and are slightly larger than the bolts they receive to allow you to use the
rail to pull the wings up or down slightly, if necessary, to get the wings parallel to the table. To do this you can
push down or pull up on the wing slightly and then tighten the nut to hold it in place.
Fig. 1
page 1
Advertisement
