Table of Contents
Advertisement
Fault
Appliance door does not
open.
Appliance door opens too
wide when activated.
Error code / Fault display / Signal
Fault
E:2060 lights up.
E:3000 lights up.
E:3100 lights up.
E:3400 lights up.
E:3200 or indicator for wa-
ter supply lights up.
1
Depending on the appliance specifications
Cause
Appliance door and door
seal are soiled.
Automatic door opening is
not in home position.
Door is not correctly adjus-
ted.
Cause
Appliance has detected cal-
cified heating element.
Water protection system is
activated.
Water protection system is
activated.
Water is continuously run-
ning into the appliance.
Supply hose is kinked.
Water tap is turned off.
Water tap is jammed or
furred up.
The filters in the water con-
nection of the supply or
AquaStop hose are blocked.
Troubleshooting aus
Troubleshooting
Clean the appliance door and door
▶
seal with a damp cloth and a little
washing-up liquid.
Wait one second after closing the
▶
appliance door.
Adjust the appliance door as de-
▶
scribed in the installation instruc-
tions.
Troubleshooting
Descale the appliance.
1.
Operate the appliance with the wa-
2.
ter softening system.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 57.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 57.
Turn off the water tap.
1.
Call "Customer Service"
2.
→ Page 57.
Install the supply hose without
▶
kinks.
Turn on the water tap.
▶
Turn on the water tap.
▶
The flow rate must be at least 10 l/
min when the water supply is open.
Switch off the appliance.
1.
Pull out the mains plug.
2.
Turn off the water tap.
3.
Unscrew the water connection.
4.
1
45
Advertisement
Table of Contents
