8. INSTALLER CHECKLIST
Your installer must have completed and
checked the following:
The dishwasher is square and level.
•
The dishwasher is fastened securely
•
to the cabinetry.
The dishwasher door opens and closes
•
freely. The dishwasher door must
close without hitting any cabinetry or
counter top.
The inlet water supply is turned on
•
and checked for leaks.
The drain hose has been connected
•
and checked for leaks. There must be
no kinks or obstructions in the drain
hose.
The drain hose must be installed with
•
a 28" (710mm) high drain loop for drain
hook-ups without any air removed.
If the dishwasher drain is hooked up to
•
a garbage disposal, the drain hopper
plug must be removed.
The spray arms are free and rotate
•
freely.
The rinse cycle has been run.
•
The water level will be below the
•
filter screen after the end of the wash
program. It is normal to find some
water in the drain filter area.
9. SELF HELP HINTS:
The screen does not come on:
Check to make sure the breaker to the
•
dishwasher is in the on position.
Check to make sure that the Supply
•
cord is plugged.
No Water is coming into the
dishwasher:
Check to make sure the hot water
•
shut-off is in the ON position.
Water does not drain:
Make sure drain hose is not kinked or
•
comes out of air gap next to the sink.
Remove drain hose from disposal
•
making sure plug is removed.
NOTICE :
If your dishwasher is not operating
•
properly after following these steps:
Contact your dealer to schedule an
authorized service agent to inspect
your new dishwasher for any function
related failure.
The manufacturer warranty does
•
not cover installation, conversion or
customer education service visits.
You will find the model and serial number
information on the label located on the
right-hand side of the inner door of your
dishwasher, as shown above.
NOTICE :
Please make a copy of your invoice and
keep it with this manual and register your
dishwasher on-line.
27
USA