Installation Instructions; Safety Precautions; Before Installing; Unpacking - Bosch HBL6EI231 Instructions For Installation And Use Manual

INSTALLATION INSTRUCTIONS

Safety precautions

Read and store these instructions carefully. Safe use can only
be guaranteed if the appliance has been installed by a
professional and in accordance with these assembly
instructions.
The appliance must be connected to the mains only by a
licensed and trained technician.
If you wish to convert to a different type of gas, call the after-
sales service.
The fitter or the installer is liable for damage or faults resulting
from incorrect assembly or installation.

Before installing

These instructions are intended for several models. Details may
vary, depending on the appliance model.
Read the following information about the appliance and the
guidelines for ventilation.

Unpacking

Check the appliance for damage after unpacking it. Do not
connect the appliance if it has been damaged in transport.
Dispose of packaging in an environmentally-friendly manner.

Appliance dimensions

Take note of the specified dimensions.



14
 
 

When installing the appliance you must observe the building
regulations that are currently applicable and the regulations set
by the local electricity and gas suppliers (e.g. Germany: DVGW-
TRGI/TRGF; Austria: ÖVGW-TR).
Switch off the power and gas supply before carrying out any
work.
The information on the rating plate regarding voltage, gas type
and gas pressure must comply with the local connection
conditions.
Electrical appliances must always be earthed.
This appliance must not be installed on boats or in vehicles.

Installation positions

The appliance can be fitted in the following positions:
Underneath a worktop
■
Above another appliance
■

Fitted units

Fitted units and adjacent unit fronts must be heat-resistant up to
at least 90 °C.

Rating plate

The technical data for the appliance can be found on the rating
plate.
The rating plate is on the side of the oven door.
The setting values are specified on a label on the appliance
packaging.
Enter the product number (E no.), production number (FD no.),
factory settings for the type of gas/gas pressure and, if
applicable, the converted gas type into the table below. The
changes made to the appliance and the type of connection are
crucial for the safe and correct operation of the appliance.
E no.
After-sales service O
Type of gas/gas pressure
Factory setting
Type of gas/gas pressure
Conversion
FD no.