Projector Control - Sony VPL-FE100U Series Quick Start Reference Sheet

This document describes the SmartPanel Projector Driver for the Sony VPL-FE100U projector. For
general information on configuring and using the Panel, see the SmartPanel Configuration and Installation
Guide.
NOTE: The Sony projector must be specially configured during installation. For instructions on
configuration requirements, see the Special Control Note in Section III below.
I. PROJECTOR CONTROL
A. Volume and Power Control
Volume control on the Sony is relative. However, on-screen display indicates the current volume level.
Absolute volume control is possible with use of SP Controls' optional Audio Follow Video Pre-Amplifier.
B. Input Selection Mapping
The following table specifies the factory-preset input mapping for this Driver. The Configuration Utility
can be used to customize these settings your installation.
Selection 1: VIDEO
Selection 2: S-VIDEO
Selection 3: INPUT A
Selection 4: INPUT B
Input choices available for this Driver are VIDEO,
S-VIDEO, INPUT A, INPUT B, and INPUT C.
NOTE: Input-type must be specified for Inputs A, B, and C for this projector. See the Special Control
Note, Section III for more information.
NOTE: INPUT B and INPUT C do not ship with the projector and must be custom-ordered.
C. Hidden Function Mapping
The following table specifies the factory preset hidden function mapping for this Driver. The
Configuration Utility can be used to customize these settings your installation.
Selection 1: APA (AUTO IMAGE)
Selection 2: ENTER
Selection 3: ADJUST LEFT
Selection 4: ADJUST RIGHT
Off: MENU
Volume Up: ADJUST UP
Volume Down: ADJUST DOWN
Hidden functions are accessed by pressing the indicated key while the holding the On key down. Hidden
functions names are based on the Sony remote and the controls on top of the projector.
DR-SNY04 - 11/7/01 SP Controls reserves the right to modify specifications without notice at any time.
Projector Driver Application Note
Sony VPL-FE100U Series
INPUT A
S-VIDEO
VIDEO
ADJUST
LEFT
ENTER
APA
Revision A
INPUT B
Projector Volume
ON ON ON ON
Ready
Warm-up
OFF OFF OFF OFF
ADJUST ADJUST
RIGHT
UP
Projector Volume
ON ON ON ON
Ready
Warm-up
OFF OFF
OFF OFF
ADJUST
MENU
DOWN