Extreme Networks Campus Controller E2122 Installation Manual page 18

Configure the Management Interface via Console Port
3. Using the console session, perform the following:
a. At the password prompt, type user: admin
b. For the initial password, type: abc123
c. Press Enter
4. Read the configuration script paragraph.
The configuration script will walk you through configuring the following information:
•
Admin Password
•
Host Attributes Settings
•
Time Settings
•
SNMP Settings
•
Data Plane Settings
5. At the end of each session, if you enter Yes, the next session will begin.
If you answer No, the session configuration is repeated.
6. Press ENTER.
After the final session is applied, the Appliance Post Installation Configuration Menu opens.
7. Type A to apply settings and exit or a number for repeating the setup.
8. Connect to a port on which management access was enabled during the CLI Wizard Setup.
9. Open a web browser and type the following in the address bar: https://
Your_Mgmt_Ipaddress:5825.
The Extreme Campus Controller login screen is displayed.
10. Log in, as follows:
•
Username: admin
•
Password: abc123 or the password that was created when setting up the installation wizard
Related Topics
Configure the Management Interface via Management Port
18 Extreme Campus Controller™
Note
An installation wizard is available to help configure the E2122 for new deployments. Refer
to the Extreme Campus Controller User Guide on the
information.
Initial Network Connection and Configuration
documentation site
on page 19
for more