Advertisement
EPA ADJUSTMENT
Function
Use this when performing left and right
steering angle adjustments. End Point
Adjustment (EPA) adjusting value range: 0%-100%
Setting
1. Steering (right side) angle adjustment Rotate "ST/R"
knob to the left end point means minimum value 0%,
right end point means maximum value 100%.
2. Steering (left side) angle adjustment Rotate "ST/L"
knob to the left end point means minimum value 0%,
right end point means maximum value 100%.
CAUTION:
When adjusting this function, make sure the direction is in agreement
with the boat direction, you can adjust by the STEERING "REV-NOR" button.
TRIM ADJUSTMENT
Steering trim
Adjust "ST/TRIM" "R/L" so that rudder is centered prior to operation, you may adjust
this control to make the boat run straight during operation.
CAUTION:
When adjusting steering trim, make sure the direction
is in agreement with the boat direction, you can adjust
by the STEERING "REV-NOR" button.
Throttle trim
Adjust "TH/TRIM" "B/F" to stop propeller from turning
while the throttle trigger is in the neutral position.
MAINTAINING THE DRIVESHAFT
Lubricating the flexshaft is vital to the life of the drivetrain. The lubricant
also acts as a water seal, keeping water from entering the hull through
the stuffing tube. Lubricating the flexshaft, propeller shaft after every
2 or 3 times of operation.
1. Use the 2mm Allen key to loose the two grub screws of the coupler
which connects the flexshaft, then slide the flexshaft w/ prop shaft
out of the stuffing tube.
2. Lubricate the flexshaft w/ prop shaft with the water proof marine
grease, reinstall the flexshaft w/ prop shaft in reverse order, be
sure to retighten the two grub screws of coupler.
IMPORTANT -
The bearing in the water cooled motor mount must be regularly
lubricated with oil, grease or Vaseline petroleum jelly to prevent
corrosion through the ingress of water.
Insufficient lubrication may lead to the premature failure of the
bearing. Note: Image shows drive shaft removed for clarity - the
bearing can be lubricated with the drive shaft in situ.
Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat
5
Steering reverse switch
Mad Shark
Steering reverse switch
Lubricate Here
Advertisement
