Advertisement
SELF-RIGHTING FEATURE
Intelligent hull design with self-righting feature, separated left part of hull laser cutted with holes. When
boat accidentaly turn over in high speed racing in big wave, don't worry, please wait for a while, the
water will come into left part of hull through holes, changing the CG of boat, then it will automatically
self-righting and keep racing, water will be drained out from the hole of rear hull.
AFTER USE
1. When you have finished using your Mad Shark, you should first switch 'OFF' the model (disconnect
the 11.1V LiPo), then switch 'OFF' your transmitter.
2. Remove all batteries from the transmitter and model.
3. Leave Mad Shark 's upper deck off to allow moisture to evaporate. Ideally, place the model in this
way in a warm and dry place, like an airing cupboard, until you are sure it is dry and then store it away.
4. Remove the rubber ring from the slot of hull, so as to keep the rubber ring flexible for water proof
effective in next time boat racing.
NOTE: If Mad Shark begins to bob when running, it may have taken on an excessive amount of water.
In this case, you should immediately return to shore, remove the upper deck and drain the
water from the hull.
TRANSMITTER INTRODUCTION
Throttle trim-brake
Throttle trim-forward
Power indicator
Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat
4
Steering reverse switch
Steering trim-right
Steering trim-left
Steering traveling angle-right
Steering traveling angle-left
Power switch
Advertisement
