Advertisement
Quick Links
MAD SHARK V2 2.4GHz ARTR BRUSHLESS Mini F1 SPEED BOAT
CONTENTS OF SET
1) Mad Shark V2 Racing Boat
2) Transmitter
3) Spare Nylon Propeller
4) Deans Plug W/Heat Shrinking Tube
3
4
Caution for LiPo battery:
ESC with low voltage hard cut off at 3.2V per cell, when driving your boat , as soon as you notice boat
stop, that means ESC low voltage cut off effective, you should immediately drive boat back to shore in
slow speed , recharge battery and race again. don't keep racing boat when ESC low voltage cut off
effective, otherwise, you will allow battery over discharge, battery voltage will reach very low and
won't be recharged again.
ATTENTION:
Before racing your model boat, carefully check silicone tube for guarantee good water cooling system;
Avoid water inlet on the bottom of hull become deformed, otherwise, water cooling system failure, this
may lead to ESC burned out and motor defected.
IMPORTANT
Mad Shark is designed for use in fresh water only.It is not designed for use in salt water!
Mad Shark is not intended for persons under 14 years of age, unless closely supervised by an adult.
This model is capable of over 45 KPH, Personal injury or property damage may result from misue of
this product, take care and enjoy your model responsibly.
Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat
SKU #BNC1032-001
5
6
5) Boat Stand
6) Water proof ballon for RX
7) Rubber Band
8) 2.5mm Allen Key (For pushrod tighten)
2.0mm Allen Key (for Grub Screws)
7
8
Advertisement
Summary of Contents for Bancroft MAD SHARK V2
- Page 1 MAD SHARK V2 2.4GHz ARTR BRUSHLESS Mini F1 SPEED BOAT SKU #BNC1032-001 CONTENTS OF SET 1) Mad Shark V2 Racing Boat 5) Boat Stand 2) Transmitter 6) Water proof ballon for RX 3) Spare Nylon Propeller 7) Rubber Band 4) Deans Plug W/Heat Shrinking Tube 8) 2.5mm Allen Key (For pushrod tighten)
-
Page 2: Installing Transmitter Batteries
1. Switch on transmitter power, the light glows bright red. 2. firstly rotate the plastic lock underneath the boat head, then rotate the four plastic lock at the hatch as photo show to remove the hatch. Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat... -
Page 3: Transmitter/Receiver Binding
Note 1: During binding process, transmitter and receiver should be no more than one meter apart and no other similar devices should be within 10 meters. Note 2: if the green light flashing, showing the binding failure, please do again as above indication. Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat... -
Page 4: Self-Righting Feature
In this case, you should immediately return to shore, remove the upper deck and drain the water from the hull. TRANSMITTER INTRODUCTION Steering reverse switch Steering trim-right Throttle trim-brake Throttle trim-forward Steering trim-left Steering traveling angle-right Steering traveling angle-left Power indicator Power switch Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat... -
Page 5: Trim Adjustment
Insufficient lubrication may lead to the premature failure of the bearing. Note: Image shows drive shaft removed for clarity - the bearing can be lubricated with the drive shaft in situ. Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat... -
Page 6: Troubleshooting
To Purchase Spare Parts or for Technical Assistance,Visit www.motionrc.com or www.motionrc.eu BNC1032-100 Bancroft Mad Shark Brushless Motor BNC1032-101 Bancroft Mad Shark Deck(Red) & Water Proof Gasket With Plastic Lock Set BNC1032-104 Bancroft Flex Shaft Set For Mad Shark BNC1032-102 Bancroft Scale Outboard Engine And Rudder Set BNC5077-002 Bancroft P1.4X35mm Φ3.1mm Two BLade Nylon Propeller (Pk2)