Tripp Lite DMR1015X3 Owner's Manual page 5

1b. Solid Brick and Concrete Mounting
• When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar
joints! Be sure to mount in a solid part of the block, generally 1" (25mm) minimum
from the side of the block. It is suggested an electric drill on a slow setting be used
to drill the hole instead of a hammer drill to avoid breaking out the back of the hole
when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
16-11-187-933680.indb 5
Concrete Anchor
WARNING
5
60mm
(2.4")
ø 10mm
(ø 0.39")
1
exact location of
mounting holes.
2
Drill pilot holes.
Washer
Anchor Bolt
Screw the wall
plate onto the
wall.
12/15/2016 10:24:57 AM
Mark the