Introduction; Safety Rules - Kruger KB650 GT Use And Maintenance Manual

KB 650/850 GT-ET
This instruction manual is designed as a guide and contains the practical
information needed for operating, adjusting and performing routine
maintenance on your new machine. Your machine has been designed and
built to ensure maximum performance, comfort and operating simplicity under
a wide range of conditions.
Before being delivered, your machine has been tested in the factory and by
our dealer to guarantee that it is in perfect condition. To keep the machine in
such conditions or to ensure problem-free operation, the operations described
in this manual must be performed. Before using the machine, read this manual
carefully and always keep it handy for future consultation.
Any "left" or "right" indications are always defined with reference to the
machine forward movement direction. If additional information about the
machine is required, do not hesitate to contact our dealer. He has the skilled
personnel, the original parts and the tools needed to meet your requirements.
The machine should not be used without protection devices. For your safety,
make sure that all safety guards are closed or mounted correctly before
starting up the machine.

SAFETY RULES

Carefully follow the rules described below to avoid injury to the operator and
damage to the machine.
−
Carefully read the labels on the machine do not cover them for any
reason and replace them immediately if they become worn-out or
damaged.
−
The machine storage temperature should range between 0° C and +50° C.
−
The best working temperature has to be included between 0° C and 40°C.
−
Humidity should range between 30 and 95%.
−
Do not use the machine as a transport vehicle.
−
Do not allow the brushes to operate while the machine is stationary to
avoid damaging to the floor.
−
In case of fire, use a powder extinguisher. Do not use water.
−
Do not bump into shelves or scaffolding where there is a risk of falling
objects.
−
Adjust the operating speed to the floor adhesion.
−
Avoid any possible instability condition.
−
When machine operating malfunctions occur, make sure that they are not
caused by a lack of routine maintenance. If not, call for assistance from
the authorised service centre.

INTRODUCTION

34