Luxen Home WHF729 Instruction Manual

Cement/iron raised stone finish outdoor patio fountain with led light

Advertisement

Product Name:
SKU #:
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
01 Fountain
02 Pump w/ Adaptor
03 LED Connector
04 Fountain Cover
05 Stand
Tools required for assembly: No tools required for assembly.

Assembly Instructions:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the fountain and stand on a flat, level surface. From the opening at the back of the fountain base,
insert the water supply tube into the pump outlet. Place the pump upright in the basin and draw the pump
power cord out of the fountain back. Place the LED connector to pump cord and twist to tighten then place
cover flat on top. (①)
4. Add clean water into the basin. The water level should be approximately 1.18in (30mm) lower than the edge
of the basin. The pump will be submerged in the water. (②)
5. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended. (③)
6. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
7. Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
8. Check the area around your fountain on a regular basis to ensure that there is no leakage.
9. Please refresh the fountain with water each week to ensure it in good condition.
10. Do not add any harmful chemicals to the water as it may alter the paint finish.
Cement/Iron Raised Stone Finish Outdoor Patio Fountain with LED Light
WHF729
Accessories standards and type
PT333-LV
Contact: sales@winsomehouse.com
Please save this manual for future reference.
Quantity
1
1
1
1
1
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WHF729 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Luxen Home WHF729

  • Page 1 Product Name: SKU #: WHF729 Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest standards of safety and quality. PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY. Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged parts.
  • Page 2 Instruction Manual Please save this manual for future reference. Cement/Iron Raised Stone Finish Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF729 Note: The above diagram is for illustrative purposes only. Pump Instructions: Special Warnings and Cautions: CAUTION: •...
  • Page 3 Cement/Iron Raised Stone Finish Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF729 • Do not exceed the voltage shown on the pump. Check the water level regularly to ensure the pump is completely submerged during operation. The pump •...
  • Page 4 Cement/Iron Raised Stone Finish Outdoor Patio Fountain with LED Light Product Name: SKU #: WHF729 CARE & MAINTENANCE: 1. Keep the water clean – clean water will prolong the useful life of your pump. 2. Use a pre-filter on your pump if available.

Table of Contents