Cleaning Before Use; Before Using Your Unit - Kenwood KFCD55B15 Installation Instructions Manual

installation
9. Place the bottom hole of the lower door
onto the bottom hinge pin. Insert the
middle hinge pin into the upper hole of
the lower door. Tighten the pin securely.
Screw the middle hinge tightly. Cover the
remaining holes with the hole covers.
• Ensure the lower door is aligned
horizontally and vertically, so that the
seals are closed on all sides before
finally tightening the pin.
10. Place the bottom hole of the upper door onto
the middle hinge pin. Swap the position of upper
hinge cover, screws and upper hinge. Insert the
upper hinge pin into the upper hole of the upper
door. Reverse the upper hinge and screw it tightly
on its new position. Tighten the pin securely.
Cover the upper hinge with the upper hinge cover
and screw tightly.
• Ensure the upper door is aligned
horizontally and vertically, so that the
seals are closed on all sides before
finally tightening the pin.

cleaning before use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water
using a sponge or cloth. Wipe completely dry before replacing the shelves and drawers. Clean
the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to
settle.

before using your unit

Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
11