Table of Contents
Advertisement
Screen connection setting
Choose the `Screen Connection` as shown in Fig 9-8.
Fig 9-8
Read File: Load connection table file from PC, the file is saved and sent out by the
manufacturer.
Save File: Save one new connection table file after adjust parameter.
Read From HW: Read the connection table parameter which is saved to all the scan
boards in cabinets.
Send To HW: Sent the connection table parameter which is loaded to all the scan boards
in cabinets.
Save: Save the connection table parameter which is sent to all the scan boards in
cabinets. After saving, you will not need to operate again.
Save Config File: Save all the configuration which is sent to all the scan boards in
cabinets. After saving, you will not need to operate again.
Attention:
Usually we will make the connection table file and send it to the user, but if you
want use it, you must connect data cables according to data cable connection drawing
which the manufacturer provides. Otherwise you should make a new one for your own
connection.
More operation details for Nova Control system should be check in
software.
50
Advertisement
Table of Contents
