Operation - onga LTP400 Owner's Manual

INSTALLATION (Continued)
4) Allow for control valves in suction and discharge piping. (Essential if pump
is mounted below water level).
5) Have adequate floor drainage to prevent pump being immersed in water due
to flooding.
6) Protect from excess moisture, vermin, dust and weather.
7) Allow access for servicing pump and piping.
8) To provide adequate ventilation keep rear of motor clear (100mm Min)
9) Do not use electrical extension cords/leads.

OPERATION

NEVER run pump dry! Running pump dry may damage
seals, causing leakage and flooding! Fill pump with
water before starting motor.
Electrical Operation
240 volt single phase are supplied as standard with built-
in thermal overload protection and are designed to plug
direct into a 10 amp domestic power supply socket to
local electrical authority specifications. Onga recom-
mends that an earth leakage/residual current protection
device must be fitted to all installations.
Do not block pump suction! To do so with body
may cause severe or fatal injury. Small children
using pool must ALWAYS have close adult
supervision!
5