Table of Contents
Advertisement
Problem
The indicator light
comes on. and
continue to flash after a
programme has been
cancelled despite thor-
ough cleaning.
The indicator light
comes on after a pro-
gramme has been can-
celled and a signal
sounds.
Cause and remedy
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the fault
message appears again. It is likely that the filter con-
tains residue further down inside that could not be
removed.
To deactivate the message, turn the programme
selector to the position.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in "Problem solving guide – Checking the heat ex-
changer".
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in "Problem solving guide – Replacing the
plinth filter".
If the plinth filter is not out of shape or damaged,
you can reactivate it in a washing machine. Follow
the instructions described in "Problem solving
guide – Reactivating the plinth filter".
The condensed water container is full or there is kink
in the drain hose.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Empty the condensed water container.
Check the drain hose.
See "Cleaning and care".
Problem solving guide
53
Advertisement
Table of Contents
