Measuring Procedure; Type J/T/E/R/S Measurement - Aktakom ATE-2036 Operation Manual

4. MEASURING PROCEDURE

4-1 Type K measurement
1) Power on the meter by pressing the " Power button "
( 3-2, Fig. 1 ) once.
* After already power on the meter, pressing the
" Power button " once ( > 2 sec ) will turn off
the meter.
2) Meter default Temp. sensor type is Type K, the display
will show " K " indicator.
The default temperature unit is
to change the Temp. unit from
please refer to Chapter 7-5, page 18.
3) Insert the Type K probes into the " T1, T2, T3, T4 input
socket " ( 3-9, Fig. 1 ).
The LCD will show the 4 channels ( T1, T2, T3, T4 )
temperature value at the same time.
* If the certain channels do not insert the temperature
probes, the relative channel display will show over
range " - - - - - ".

4-2 Type J/T/E/R/S measurement

All the measuring procedures are same as the Type K (
section 4-1 ) except to select the Temp. Sensor type to
" Type J/K/T/E/R/S " by pressing the " Type Button " ( 3-5,
Fig. 1 ) once in sequence until the up LCD display show
" J/T/E/R/S " indicator.
( ), the method
℃ ℉
to
℃ ℉
7
or to ,
℉ ℃