Williams OVERTURE III Owner's Manual page 15

Octave
This function will transpose the piano keyboard up
or down by up to two octaves.
There are two kinds of Octaves. One is for full
keyboard octave the other is for split mode (left
hand) octave.
To Transpose the Full Keyboard:
1. Press and hold the [OCTAVE] button. The display
will show the current full keyboard Octave setting
in the lower right-hand corner of the display.
2. While the Octave screen is on you can turn the
Value Dial to select the Octave. (+ 2 or -2)
When in split mode, the regular Octave button
function will only adjust the main (right hand)
octave.
To Change the Split (left hand) Octave:
1. Press the [FUNCTION] button.
2. Turn the Value Dial to select Split Octave edit
menu. The display will show "Split Octave".
3. Press the Function button again to enter the
parameter edit menu. The FUNC indicator will
blink to indicate the value is editable.
4. Turn the Value Dial to select Split Octave.
(+2 or -2)
Piano Reset
If you want to quickly reset the keyboard to the
default transposition, Octave ranges and effects,
you can do so by pressing the Transpose and
Octave buttons simultaneously.
W ILLIAM S P IAN OS. CO M
OVE RTU R E I I I D I G ITAL P IAN O
LAYER MODE
To Layer Two Sounds:
1. Select your main voice using the Voice Select
button or Value Dial.
2. Press any two Voice Select buttons
simultaneously to activate layer mode. The Layer
indicator in the bottom left-hand corner of the
screen will flash to indicate that you are editing
the layer voice.
3. Choose your layered voice using the Voice Select
buttons or Value Dial.
4. Wait 5 seconds for the Layer indicator to stop
flashing, and the Display will switch back to
showing your main voice. The Layer indicator
will stay fully lit to indicate that your layer is still
active. You may choose a new main voice at any
time while layer mode is active.
Press any two Voice Select buttons simultaneously
again to deactivate layer mode. Follow steps 1-4 to
choose a new layered sound.
To Change the Layer Volume Level:
1. Press the [FUNCTION] button.
2. Turn the Value Dial to select the Layer Volume
Level edit menu, the display will show "Layer
Volume".
15