Advertisement
ASSEMBLY (Note: When fastening with nuts
and bolts, always use a washer (#19 or #20)
between the tube and the bolt or the tube and
the nut.)
Step 1:
Fasten the front and rear upright supports (#2
and #3) at the top by using bolts (#13), washers
(#19), and plastic nuts (#21). Repeat the same
procedure for both sides. Keep the bolts loose.
See Fig. A – Step 1.
Step 2:
At both ends, insert the assembled upright
supports (#2 and #3) into the top cross beam
w/adjustable teeth (#1). Tighten all of the plastic
nuts and bolts now. See Fig. A – Step 2.
Step 3:
Fasten the lateral cross braces (#4) to the
upright supports (#2 and #3) by using bolts
(#14), washers (#20), and plastic nuts (#22).
Repeat the same procedure for both sides.
See Fig. A – Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#14),
washers (#20), and plastic nuts (#22). Tighten
all of the nuts and bolts. See Fig. A – Step 4.
Step 5:
Insert the leg caps (#12) into all of the base feet.
See Fig. A – Step 5.
25
13
25
13
Step 1
Fig. A
STOP
DON'T RETURN TO STORE!
PAGE 3 OF 6
19
19
21
19
19
21
3
2
Do not tighten the bolts
after step 1, fasten all of
the bolts after Fjg A.
Step 3
3
2
2
4
Step 4
3
5
Step 5
3
2
12
12
1
Step 2
3
2
2
26
14
3
20
20
4
3
20
20
14
26
3
2
12
12
3
22
22
Advertisement
