Table of Contents
Advertisement
Quick Links
O
PERATOR
S
AND
ERVICE
GPR44
is manual covers the following serial numbers
and higher for each model listed:
GPR78...........................................7800110
VIBRATORY PLATES
MBW, Inc.
250 Hartford Rd • PO Box 440
Slinger, WI 53086-0440
Phone: (262) 644-5234
Fax: (262) 644-5169
Email: mbw@mbw.com
Website: www.mbw.com
'
S
S
AFETY
M
ANUAL
MBW Europe Ltd.
Units 2&3 CochraneStreet
Bolton BL3 6BN
England, UK
Phone: 44 (0) 01204 387784
Fax: 44 (0) 01204 387797
E-mail: mbweurope@mbw.com
Website: www.mbweurope.com
MBW FRANCE S.A.R.L.
French Contact
Z.A. d'Outreville
Jean-Michel Aucan
Phone: +33 (0)625 823 307
11
Rue
Jean
Baptiste
E-mail: jma@mbw.com
Néron,
60540 BORNEL
France
Email: mbwfrance@free.fr
Phone:+33 (0) 3 44 07 15 96
L19604 / 04.14.D
©MBW, Inc. 2016
©
Advertisement
Table of Contents
Related Manuals for MBW GRP44H4
Summary of Contents for MBW GRP44H4
- Page 1 ANUAL GPR44 is manual covers the following serial numbers and higher for each model listed: GPR78...........7800110 VIBRATORY PLATES MBW Europe Ltd. MBW, Inc. MBW FRANCE S.A.R.L. French Contact Units 2&3 CochraneStreet 250 Hartford Rd • PO Box 440 Z.A. d’Outreville...
-
Page 2: Table Of Contents
ABLE ONTENTS Safety Information ..... . 1 Parts Replacement Cycles and Tolerances ..Introduction ....... . . 1 Safety Precautions . - Page 3 WARNING CALIFORNIA PROPOSITION 65 WARNING Engine exhaust and some of its constituents are known in the state of California to cause cancer, birth defects, and other reproductive harm.
-
Page 4: Safety Information
MBW does monoxide, a poisonous, odorless, invisible not by the publication of these precautions, imply or in any gas. Death or serious illness may result if way represent that these are the sum of all dangers present inhaled. -
Page 5: Specifications
PECIFICATIONS GRP44H4 GPR44D 1530 kgf (15 kN) 1530 kgf (15 kN) CENTRIFUGAL FORCE 6000 vpm 6000 vpm EXCITER (VPM) TRAVEL SPEED 82 ft./min. (25 m/min.) 82 ft./min. (25 m/min.) 35 X 88.6 cm 35 X 88.6 cm WIDTH x LENGTH... -
Page 6: Safety Decals: Gpr78H (Decal Set #16031)
Compactor, inspect it for any visible damage done during shipment. Make sure the engine throttle works properly. Starting Diesel Engine Contact your nearest MBW Inc. Distributor if there are any problems. For detailed instructions refer to the engine Manual. Your new MBW Inc. Reversible Plate Compactor is When starting the engine, the throttle lever on the shipped complete and ready for use. -
Page 7: Stopping Engine
Stopping Engine WARNING To stop the compactor from traveling forward, return Always stop the engine before: the engine throttle to idle position. Adding fuel. Whenever possible, it is recommended to let the engine idle for one or two minutes before stopping. Leaving the equipment unattended for any amount of time. -
Page 8: Maintenance
4 oz. Chevron AW ISO or Rykon 32 Engine Refer to engine operator/owner manual MBW #01058 ---- 6-Pack (8 oz. bottles) MBW #17320 ---- 1 quart (32 oz.) Engine Maintenance The engine operating speed should be set to 3600 RPM. -
Page 9: Service
ERVICE Assembly and disassembly should be performed by a Service Tools service technician who has been factory trained on MBW equipment. The unit should be clean and free of debris. Part No. Description Pressure washing before disassembly is recommended. 17320 Ground Pounder®... -
Page 10: Parts Replacement Cycles And Tolerances
Parts Replacement Cycles and Tolerances Replace anytime a bearing is rough, binding, discolored or removed from housing or Bearings shaft. Clutch Replace clutch if it does not disengage below 1800 rpm. Engine Components Refer to your engine manufacturer’s Owner’s Manual. Replace any worn or damaged hardware as needed. -
Page 11: Replacement Parts
Their sales engineers are available for professional consultation. If you cannot locate an MBW distributor in your area, contact MBW or one of our Sales Branches listed below. When ordering replacement parts, be sure to have the following information available: •... -
Page 12: Main Assembly
Main Assembly... - Page 13 S/NO PART NO DESCRIPTION REMARK -60-1B BASE HONDA GX160 01444 -60-3B BOLT M8X40T -60-4B SW M8 -60-5B PW M8 -60-6B BELT COVER PLATE F052406HCS BOLT PLAIN WASHER F05SW -60-10B CLUTCH ASSEMBLY -60-11B COUNTERSUNK WASHER 01099 F052408FSS FLAT HEAD SOCKET SCREW -60-14B V-BELT -60-15B...
-
Page 14: Handle Assembly
Handle Assembly... - Page 15 S/NO PART NO DESCRIPTION REMARK -60-1D THROTTLE LEVER ASSEMBLY -60-2D THROTTLE WIRE -60-3D HANDLE AY -60-5D BOLT M16X145T -60-6D PW M16 -60-7D CONICAL SPRING VASHER M16 -60-8D NUT M16 -60-9D SHOCK ABSORBER, STOPPER -60-10D NUT M10 -60-11D SW M10 -60-12D HAND PUMP ASSEMBLY -60-13D TRAVEL LEVER...
-
Page 16: Base Plate Assembly
Base Plate Assembly... - Page 17 S/NO PART NO DESCRIPTION REMARK -60-1A VIBRATING PLATE -60-2A SHOCK ABSORBER -60-3A NUT M10 -60-4A SW M10 -60-5A BOLT M10X30T -60-6A SW M10 -60-7A WASHER -60-8A OIL GAUGE -60-9A PACKING...
-
Page 18: Vibrator Assembly
Vibrator Assembly... - Page 19 S/NO PART NO DESCRIPTION REMARK -60-C VIBRATOR ASSEMBLY -60-1C VIBRATING CASE -60-2C ROLLER BEARING 6206C4 -60-3C ROTARY SHAFT, DRIVE -60-4C ROTARY SHAFT, DRIVEN -60-5C STOP RING S-35 -60-6C KEY 10X8X19 -60-7C GEAR (DRIVE) -60-8C GEAR (DRIVEN) -60-9C BEARING 6807C3 -60-10C PISTON ROD -60-11C PIN 8X45...
-
Page 20: Hand Pump Assembly
Hand Pump Assembly... - Page 21 S/NO PART NO DESCRIPTION REMARK -60-1E CAN COMP (PUMP) -60-2E COVER (HAND PUMP) -60-3E PISTON CP -60-4E CONTROL SHAFT (PUMP) -60-5E BUSH -60-6E CAN (PUMP) -60-7E BEARING 607ZZ -60-8E SPACER -60-9E PIN 7X30 -60-10E SPRING PIN -60-11E SPRING (PUMP) -60-12E STOPPER (PUMP) -60-13E PLUG...
-
Page 22: Water Tank Assembly (Optional)
Water Tank Assembly (optional) - Page 23 S/NO PART NO DESCRIPTION REMARK -60-1F WATER TANK ASSEMBLY -60-2E CAP, WATER TANK -60-3E BOLT M10×30 -60-4E WASHER 10.5×21×2 -60-5E NYLON NUT M10 -60-6E WASHER 14.5×30×1.6 -60-7E PACKING 13×28×2 -60-8E COCK -60-9E SPRINKLING PIPY -60-10E PIPE HOLDER LEFT -60-11E PIPE HOLDER RIGHT -60-12E PLANGE BOLT M8×25 -60-13E...
-
Page 24: Warranty
1.This warranty does not cover any Used Equipment. "Used Equipment" such replacement or repair is the exclusive remedy provided hereunder. means any MBW machine or equipment that is not a New Machine or a Labor must be performed at an authorized MBW distributor. MBW Demonstration Machine.