Setting
Buzzer
Auto CR (IBM 2380
Plus)*
IBM character
table*
Data length 7/8 bit
(serial I/F)
EXT/ACK (serial I/F)
Tractor
Character spacing
* These settings take effect only when IBM 2380 emulation is selected.
To enter the Default Setting mode, make sure the printer is off
and paper is loaded. Then hold down the Tear Off button and
press the power switch to turn on the printer. Instructions are
printed which you can follow to change any settings. When you
are finished, turn off the printer to exit the Default Setting mode.
See Chapter 2 in your LX-300+ User's Guide for instructions on
using the default setting mode.
Using the EPSON Remote! Utility
The printer software CD-ROM contains a new utility called
EPSON Remote! which provides another way to change the
default settings. Follow the steps below to install and use the
utility.
10
LX-300
not available
On, O O O O f f f f f f f f
not available
7 bit, 8 8 8 8 b b b b i i i i t t t t
D D D D i i i i s s s s a a a a b b b b l l l l e e e e , Enable
S S S S i i i i n n n n g g g g l l l l e e e e , double
1 1 1 1 0 0 0 0 c c c c p p p p i i i i , 12 cpi
LX-300+
O O O O n n n n , Off
On, O O O O f f f f f f f f
Table 1, T T T T a a a a b b b b l l l l e e e e 2 2 2 2
8 bit only
not available
not available
Not selectable through
Default Setting mode. To
select spacing other than
10 cpi (the printer's
default), such as 12, 15,
17, or 20 cpi, use ESC/P
command).