Bernini 2-in-1 Hummingbird & Bird Seed Feeder Owner's Manual

2-in-1 Hummingbird & Bird Seed Feeder Owners Manual

CONTENTS:

Hanging
Hoop
Hanging
Cable
Lock
Button
Bird Seed
Food Dish
Hummingbird
Food/Water
Reservoir
Flower Cover
Port
Hummingbird
Diagram 1:
Perch Ring
Please note, images of parts are not to scale with one another.
Hanging Hoop
Lock Ring
UPPER BIRD FEEDER
Upper Bird Feeder Assembly
ASSEMBLY

Pre Assembly Preparation:

1. Note: The 2-in-1 Hummingbird & Bird Seed Feeder is designed for easy assembly but please use
caution when assembling.
2. Prior to assembly take time to find a suitable location for your 2-in-1 Hummingbird & Bird Seed
Bird Seed Feeder and make sure to assemble your new 2-in-1 Hummingbird & Bird Seed Feeder on spacious
Fill Cover
and clean work surface.
3. Use Diagram 1 for reference on part names, assembly and how all the individual parts fit together.
4. Observe all safety precautions.
ASSEMBLY:

Assembling The Lower Bird Feeder Assembly:

Bird Seed
Reservoir
1. On a flat even surface place the Hummingbird Food/Water Reservoir with the open end
facing up, fill with your choice of hummingbird food/water (see recommendation later in this
instruction) approximately 80% full (Figure 1 & Figure 1 arrow).
2. Set the Hummingbird Food Dish/Perch Ring upside down on the Hummingbird Food/Water
Reservoir and screw onto the Hummingbird Food/Water Reservoir. Screw past the threads
and then push onto the rib to hold Hummingbird Food/Water Reservoir in place (Figure 2).
3. Take the Hummingbird Food Dish/Perch Ring turn it upside down and screw onto the Hum-
mingbird Food Reservoir snug but DO NOT OVER TIGHTEN (Figure 3 & 4).
4. Flip the assembled Hummingbird Food Reservoir/Hummingbird Food Dish/Perch Ring over
Bird Perch
(Figure 5). The Hummingbird Food Dish will gravity feed/fill from the reservoir until an equilibri-
Ring
Ribs
um is achieved.
5. Push down the Flower Cover Port till it is free from the rib (Figure 6 small black arrow),
Thread and tighten the Flower Cover Port until snug against the Hummingbird Food Dish/
Perch Ring but DO NOT OVER TIGHTEN (Figure 7).
LOWER BIRD FEEDER

Assembling The Upper Bird Feeder Assembly:

ASSEMBLY
5. The Upper Bird Feeder Assembly comes pre-assembled. Set the Upper Bird Feeder As-
sembly Bird Perch Ring on a flat surface (Figure 7 arrow), press the Lock Button and pull up
to the Hanging Loop Lock Ring, this will allow you to lift up the Bird Seed Fill Cover. (Figure 8).
Set the Bird Seed Fill Cover to the side of the Upper Bird Feeder Assembly.
6. Fill with your choice of bird seed (see recommendations later in this instruction). Fill approx-
imately 80% (Figure 9 Black arrows).
7. Put the Bird Seed Fill Cover back onto the top of the Bird Seed Reservoir (Figure 10), press
the Lock button and pull up on the Hanging Cable to tighten (Figure 11).
Hummingbird
Food Dish
PLEASE READ THESE INSTRUCTIONS COMPLETELY
BEFORE ATTEMPTING TO ASSEMBLE YOUR NEW
2-IN-1 HUMMINGBIRD & BIRD SEED FEEDER
Hummingbird Perch Ring
& Food Dish
Flower Port Cover
Hummingbird Food/Water
Reservoir
|1