Little Giant WRS-6 Instruction Sheet page 2

Wastewater removal system with 6-cia pump

Hide thumbs Also See for WRS-6:

Basin: Sediment may build up in basin causing pump to oper-

ate improperly. Remove 10 1/4-20 screws from cover. Remove

cord grommet and loosen cords to allow slack and then remove

cover.

Remove pump and clean basin using a mild detergent and water.

Reassemble in reverse order.

Torque screws 18–20 in.-lbs.

If pump alignment plate is removed, it must be reinstalled per

pump alignment diagram.

Figure 1 - Typical Installation

PumpAgents.com - Click here for Pricing/Ordering

Pump: Sediment or lint can clog pump and cause improper

operation. If necessary, remove pump and pull off the pressed-

in screen. Clean using a mild detergent and water and reinstall.

Plastic pump base may also be removed to clean around impeller

and inside base. Remove the six base screws and clean base

using a mild detergent and water. Do not remove impeller. When

reinstalling base, be sure seal ring is seated properly in groove

and torque screws to 10–15 in.-lbs. See pump manual for other

information. For any other pump repair, return the pump to a Little

Giant authorized service center.

L506055