The printer's page length
setting may not match the
size of the continuous
paper you are using.
Regular gaps occur in the printout.
Cause
One-inch skip-over-
perforation may be set.
Paper Handling
Single sheets do not feed properly
Paper does not feed.
Cause
Continuous paper may be
left in the printer.
The paper on the paper
guide is positioned too far
to the left or right for the
printer to detect it.
84
Maintenance and Troubleshooting
Check the Page length for tractor setting
in Default Setting mode. See page 68.
What to do
Set skip-over-perforation to Off in
Default Setting mode. See page 67.
What to do
Remove the continuous paper. Set the
paper release lever to the single-sheet
position. Insert a new sheet.
Move the paper (and the edge guides) a
little to the left or right.