The Cut Sheet Feeder - Epson LQ-2550 Paper Manual

LQ-2550 GRAY DOT-MATRIX PRINTER
MCBF:
For all components excluding print head:
6000 power-on hours (at 25% duty)
Print head life:
Dimensions and weight:
Height:
W i d t h : 26.6'
Depth: 20.4'
Weight: approx. 44 Ibs
Voltage:
120 VAC + 10%
Power consumption:
Frequency:
49.5 to 60.5 Hz
Insulation resistance:
strength (between AC line and chassis):
Can withstand 1.25 kV rms applied for one
minute
Operation: 40°F to 95°F (5°C to 35°C)
Storage: -22°F to 140°F (-30°C to 60DC)
Operation: 10% to 80% (without
condensation)
Storage: 5% to 85% (without condensation)
Shock:
Operation: Up to 1 G withii 1 ms
Storage: Up to 2 G within 1 ms
Vibration:
Operation: Up to 0.25 G at up to 55 Hz
Storage: Up to 0.50 G at up to 55 Hz

The Cut Sheet Feeder

Dimensions and weight: 26,7'(W)
(mounted on the printer)
approx. 13.2 Ibs.
Bin capacity:
bin 1
Single sheets. Up to 150 sheets of 22 lb. paper
Envelopes':
bin 2
(Total thickness should not exceed 0.59' or
Stacker capacity:
Face down Single sheets:
Envelopes:
Face up Single sheets:
Envelopes:
LQ-2550-2
7.7'
I
I
X
Up to 185 sheets of 17 lb. paper
(Total thickness should not
exceed 0.59' or 15mm)
Up to 25 (plain and bond type)
Up to 30 (air mail)
Up to 185 sheets of 17 lb. paper
Up to 60 sheets of 22 lb.
Up to 75 sheets of 17 lb.
Up to 10 (plain and bond
Up to 12 (air mail)
Up to 25 (plain and bond
Reliability
MCBF (Mean Cycle Between Failure): 100.000 cycles
T e m p e r a -
Humidity:
Width
7.17' LO 14.3'
8.27' to 14.3'
Thickness
0.0028' to 0.0039'
Weight:
17 to 22 lb. paper
Printable
area :
The following is a typical example of a software setup required for
proper operation of your cut sheet feeder. Not ail software is set up the
same. so you may find that a bit of experimentation is required before
you find the best equivalent settings to use.
To maintain 54 printed lines per page make the following changes:
Top Margin
Bottom Margin
9 / 2 2 / 8 9
.
Operation:
storage:
-22°F (-30°C) to +15BaF
Operation:
condensation
Storage: 5% to 90% without
condensation
envelope
6.50' to 9.49'
3.62' to 4.09'
to 364mm)
0.0043' to 0.0205'
Continuous
Cut sheet
form settings feeder settings
66
6
6
24-Pin Printers
2 2 m m
or m*re
6 1
4
3