Table of Contents
Advertisement
Warning Symbols and Definitions
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to
avoid possible injury or death.
avoided, will result in death or serious injury.
avoided, could result in death or serious injury.
avoided, could result in minor or moderate injury.
Specifications
Electrical Rating
No Load Speed
Max. Accessory Diameter
Collet Hole Diameter
Functional Description
2
1. Power Switch
2. Collet Nut
Page 8
Indicates a hazardous
situation which, if not
Indicates a hazardous
situation which, if not
Indicates a hazardous
situation which, if not
Addresses practices not
related to personal injury.
120 V AC / 60 H z / 4 A
25,000 RPM
1-1/2" (38 m m)
1/4"
1
For technical questions, please call 1-888-866-5797.
OPERATION
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Switch is in the OFF position and
unplug the tool from its electrical outlet before
performing any procedure in this section.
TO PREVENT INJURY: Wear heavy-duty work
gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1. The accessory MUST be:
• Rated to at least 25,000 RPM.
• No larger than 1-1/2" (38 mm) in diameter.
• Fitted with a 1/4" mandrel. A different size
mandrel may be used with a matching collet.
• Undamaged.
• An abrasive cut-off wheel, sander, polisher, wire
brush or grinding wheel (accessories not included).
2. Hold the Spindle with Wrench (49), while turning
the Collet Nut with Wrench (48) to loosen.
3. Insert the accessory's mandrel into
the Collet at least 5/8".
4. Using the Wrenches, securely tighten the Collet.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
Item 56932
Advertisement
Table of Contents
