Options - Epson LQ-1050 User Manual

Options

Problem
Using the cut sheet
feeder, the paper
does not feed
properly.
The LOAD/EJECT
button is pressed, but
the platen does not
move and the paper
does not feed.
After a print command
is sent from the
computer, the platen
does not move and the
paper does not feed.
Solution
You may be pressing the
button while
the
Always take the printer off line before
feeding the paper. Paper feeds
automatically when the cut sheet feeder
receives a print command from the
computer (only while the printer is on
line).
The printer may be off line. Press the
button to put the printer on line.
ON LINE
The cut sheet feeder mode may be off.
Set DIP switch l-7 to
allows you to use control codes, use
ESC EM 4 to set the cut sheet feeder
mode. The printer
paper out condition to receive this
command. Send the command with
continuous paper loaded and with the
paper select lever in the continuous
position.
LOAD/EJECT
printer is on line.
If your program
on.
be ready with no
must
Troubleshooting
7-27