Install Support Brackets; Extend The Accordion Panels; Install The Window Lock And Sash Seal - Gree Thermocore GM-WAC-25ESE-C Operating Instructions Manual

Install Support Brackets

1. Hold each support bracket flush against the outside of
the window sill. Tighten each bracket to the bottom of
the cabinet as shown below. Mark the brackets at top
lever of the window sill and then remove.
Mark
Left
Locknut
Sill Angle
Bracket
Flat Head Bolt
2. Assemble the sill angle brackets to the support brack-
ets at the marked position as shown above. Hand
tighten, but not all the way for any changes that may
need to be made later during installation.
3. Install the support brackets (with sill angle brackets
attached) to the bottom of the cabinet as shown below.
4. Tighten all 6 bolts securely.
1/2" Long Screws
and Locknuts
Right
2 each req'd
for each sup-
port bracket
1/2" long
screw and
locknuts

Extend the Accordion Panels

1. Carefully raise the window to expose the accordion
panel and panel frame. Loosen the locking screws so
the accordion panels slide easily.
2. Extend each panel to completely fill the width of the
window. Tighten the locking screws when the panels
are fully extended.

Install the Window Lock and Sash Seal

1. Trim the sash seal to fit the width of the window. Insert
the sash seal into space between the upper and lower
sashes.
2. Attach the right angle safety lock as shown below.
10