Philips FW-C58 Manual page 7

All manuals and user guides at all-guides.com
CAUTION:
– For optimal sound performance, it is
recommended to use the supplied
speakers.
– Do not connect more than one speaker
to any one pair of + / - speaker
terminal.
– Do not connect speakers with
impedance lower than the speakers
supplied. Please refer to
SPECIFICATION section of this manual.
D Rear Surround Speakers'
Connection
Connect the black (non-marked) wires to
the black REAR SURROUND terminals and
the colored (marked) wires to the grey
REAR SURROUND terminals.
E Line Out Connection
(wireless
ready)
You can connect the audio left and right
LINE OUT terminals to a optional CD
Recorder ANALOG IN terminals. This
allows you to record in an analogue format.
You can also install additional optional
front active speakers away from the
system (e.g. in another room) to reduce the
inconvenience of running long speaker
wires across rooms. You can place as many
remote speakers as you like provided they
operate at the same radio frequency.
Untitled-5 7
Connect the wireless radio frequency
H Digital Out Connection
transmitter to the LINE OUT terminals.
You can record the digital sound from the
Place the active speakers at your preferred
CD, through this output, on any audio
location. Be sure to follow the instructions
equipment with digital input (e.g. CD
supplied with the active speakers.
Recorder, Digital Audio Tape (DAT) deck,
Note:
Digital to Analog Converter and Digital
– Availability of wireless transmitter and
Signal Processor).
its peripherals are subjected to the
Connect one end of the cinch cable (not
approval of local authorities. Please
supplied) to the DIGITAL OUT socket and
check with respective local safety or
the other end to the audio equipment with
approving authority.
digital input.When connecting the cinch
cable, make sure it is fully inserted.
F Connecting other
equipment to your system
I Adjusting the Operating
You can connect the audio left and right
OUT terminals of a TV, VCR, Laser Disc
Before connecting the AC power cord to a
player, DVD player or CD Recorder to the
wall outlet, make sure that the voltage
AUX/CDR IN terminals at the rear of the
selector at the rear of the system is set to
system.
the local power line voltage. If not, reset
the selector before connecting to the wall
G Subwoofer Out Connection
outlet.
Connect the optional active subwoofer to
J AC Power Supply
the SUBWOOFER OUT terminal. The
subwoofer reproduces just the low bass
After all other connections have been
sound effect (e.g. explosions, the rumble of
made, connect the AC power cord to the
spaceships, etc.). Be sure to follow the
system and to the wall outlet.
instructions supplied with the subwoofer.
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
Voltage
(not available for all versions)
AA batteries.
6/8/01, 10:26 AM
PREPARATION
7
3139 116 19751