Replacing The Lamp - Zanussi ZOP37912XC User Manual

2
B
Hold the door trim (B) on the top edge of the door
at the two sides and push inwards to release the
clip seal. Pull the door trim to the front to remove it.
Hold the door glass panels by their top edge and
carefully pull them out one by one. Start from the
top panel. Make sure the glass slides out of the
supports completely.
Clean the glass panels with water and soap. Dry
the glass panels carefully.
When the cleaning is completed, install the glass
panels and the oven door. Do the above steps in
the opposite sequence.
Make sure that you put the glass panels (A and B)
back in the correct sequence. The middle panel (B)
has a decorative frame. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame (B) on the screen-printing zones is not rough
when you touch it.
22
1
A B
Make sure that you install the middle panel of glass
in the seats correctly.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
A
B