How To Install The Front Wheels - Murray 385002x190A Instruction Booklet

HOW TO INSTALL THE FRONT WHEELS

Use a knife and cut the four sides of the container. Install the front
wheels in the container.
NOTE: Use a piece of wood about 4 feet (1.25 meters) long to
raise the front of the tractor. If a piece of wood cannot be found,
get another person to help lift the tractor. Be careful, do not let
the tractor fall.
1. Raise the front of the tractor. Set a support (block of wood)
under the tractor.
Hub Cap
Black Cable
1740336SM
ASSEMBLY
Cotter Pin
Valve Stem
2. Make sure the valve stem is to the outside of the tractor. Slide
the front wheel on the spindle.
3. Fasten each front wheel with washer, washer and cotter pin.
Bend the ends of the cotter pin appart to keep the front wheel
on the spindle.
4. After the front wheels are installed, lift the tractor from the
support. Roll the tractor off of the container.
5. If your tractor has hub caps, install the hub caps. Make sure
the washers hold the hub caps in place.
Washer (17x195)
Washer (17x192)
Front Wheel
12
A
Spindle
Figure 1