Table of Contents
Advertisement
Faults and what to do about them
en
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
Ì in the display panel
and drying has been
interrupted.
¥ in the display panel.
Dryer does not start.
Display panel goes off
and Start button flashes.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
Laundry is not dried cor-
rectly or is still too damp.
*
Depending on the model
32
Cause/remedy
Empty the condensate container; ~ Page 28 and the dryer; ~ Page 14.
■
If the optional condensation drain is installed, the drain hose may be
■
blocked. Check the hose for deposits and flush the hose out.
Clean the fluff filter and/or the heat exchanger, then select the Start button
~ Page 27; ~ Page 30.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the child-proof lock.
■
"Ready in" time selected? Programme starts after a delay.
■
Not a fault. Energy-saving mode is active ~ Page 12.
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
After the end of the programme, warm laundry feels damper than it actually
■
is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry becomes drier ~ Page 24.
Select a programme with a longer drying time or increase the drying level.
■
This does not increase the temperature.
Select a time programme for subsequent drying of laundry that is still damp
■
~ Page 22.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered by
■
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 31.
Drying has been interrupted as a result of a power cut, because
■
the condensate container is full or because the maximum drying time has
been exceeded.
Note:
See also the laundry tips ~ Page 21.
Advertisement
Table of Contents
