Troubleshooting; Environment Protection - Sealey TS10P.V2 Quick Start Manual

8. TROUBLESHOOTING

Problem Possible cause
Motor not running. 1. No mains voltage.
2. Undervoltage relay triggered by temporary loss of power.
3. Motor overheated.
Blade makes poor cuts. 1. Blade is dull or dirty.
2. Blade is the wrong type for cut being made.
3. Blade is mounted backwards.
Excess vibration. 1. Blade is out of balance.
2. Blade is damaged.
3. Saw is not mounted securely.
4. Work surface is uneven.
5. Blade is warped.
Bevel adjusting 1. Gear and screw post inside the cabinet are clogged with
Handwheel is hard to sawdust.
turn.
The work piece is 1. The fence is not being used.
Touching the back of 2. The saw blade is thicker than the riving knife or the riving knife
the saw blade and is is not being used.
jumping out. 3. The blade is dull.
4. The work piece has not been kept in its place until after
sawing.
5. Mitre gauge locking handle is loosen.
Saw does not make 1. Positive stops inside the cabinet need adjusting (Bevel cuts).
accurate 90°or 45° cuts.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534 sales@sealey.co.uk
Original Language Version
Solution
1. Check cable, plug, socket and fuse.
2. Switch device on again.
3. Eliminate cause of the overheating, let
cool down for a few minutes,
1. Clean, sharpen or replace the blade.
2. Replace with the proper type.
3. Remount the blade.
1. Replace blade.
2. Replace blade.
3. Tighten all hardware.
4. Reposition on flat surface.
5. Replace blade.
1. Clean the gear and screw post.
1. Use the fence.
2. Replace blade or mount the riving knife.
3. Replace blade.
4. Keep the work piece in place until finishing
the sawing.
5. Tighten the mitre gauge locking handle.
1. Adjust the positive stops.
www.sealey.co.uk
TS10P.V2 Issue: 1 12/11/2020