Table of Contents
Advertisement
is 1.6 W/kg averaged over 1 gram of body tissue. Tests for SAR
are conducted using standard operating positions with the mobile
phone transmitting at its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified power level,
the actual SAR level of the mobile phone while operating can be
well below the maximum value. This is because the mobile phone is
designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output of the mobile
phone. Before a mobile phone model is available for sale to the public,
compliance with national regulations and standards must be shown.
The highest SAR value for this model mobile phone when tested is
1.14 W/Kg for use at the ear and 1.19 W/Kg for use close to the body.
While there may be differences between the SAR levels of various mobile
phones and at various positions, they all meet the government requirement
for RF exposure. For body-worn operation, the mobile phone meets
FCC RF exposure guidelines provided that it is used with a non-metallic
accessory with the handset at least 10 mm from the body. Use of other
accessories may not ensure compliance with FCC RF exposure guidelines.
Additional information on SAR can be found on the Cellular
Telecommunications & Internet Association (CTIA) Web site: http://
www.phonefacts.net
The World Health Organization (WHO) considers that present scientific
information does not indicate the need for any special precautions for
use of mobile phones. If individuals are concerned, they might choose to
limit their own or their children's RF exposure by limiting the length of
calls, or using "hands-free" devices to keep mobile phones away from the
head and body. (fact sheet n°193). Additional WHO information about
electromagnetic fields and public health are available on the following
website: http://www.who.int/peh-emf.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
32
IP4349_903A_QG_Eng_USA_04_120822.indd 32-33
IP4349_903A_QG_Eng_USA_04_120822.indd 32-33
For the receiver devices associated with the operation of a licensed
radio service (e.g. FM broadcast), they bear the following statement:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the condition that this device does not cause harmful
interference.
For other devices, they bear the following statement:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Your mobile phone is equipped with a built-in antenna. For optimal
operation, you should avoid touching it or degrading it.
As mobile devices offer a range of functions, they can be used in
positions other than against your ear. In such circumstances the device
will be compliant with the guidelines when used with headset or usb
data cable. If you are using another accessory ensure that whatever
product is used is free of any metal and that it positions the mobile
phone at least 10 mm away from the body.
•
LICENCES
microSD Logo is a trademark.
The Bluetooth word mark and logos are owned by
the Bluetooth SIG, Inc. and any use of such marks by
TCT Mobile Limited and its affiliates is under license.
Other trademarks and trade names are those of their
respective owners.
ONE TOUCH 903A Bluetooth
QD ID B018542
TouchPal™ and CooTek™ are trademarks of Shanghai
HanXiang (CooTek)Information Technology Co., Ltd.
and/or its Affiliates.
The Wi-Fi Logo is a certification mark of the Wi-Fi
Alliance.
Your device uses non-harmonised frequency and is
intended for use in all European countries. The WLAN
can be operated in the EU without restriction indoors,
but cannot be operated outdoors in France.
Google, the Google logo, Android, the Android logo,
Google Search, Google Maps, Gmail, YouTube, Google
Play Store, Google latitude and Google Talk are
trademarks of Google Inc.
33
2012-8-22 17:15:34
2012-8-22 17:15:34
Advertisement
Table of Contents
