Operating Program - Skyrc SK100157 Instruction Manual

Operating Program

Here is the detailed procedure to make the charger work. All the screens and operations
will take Li-Po BALANCE CHARGE program for example,
Note: We will explain the operating procedure of one channel as
the procedure for channel A and B is identical..
1. Connection
1). Connecting to power source
There are two kinds of inputs for SKYRC D260, DC 11-18V and AC 100-240V.
A. Operating in AC mode
SKYRC D260 comes with built-in switching power supply. You can connect the AC
power cord directly to the main AC socket. (100-240V AC).
Note: The output power in AC/DC mode is rated 130W for both Channel A and
Channel B.
B. Operating in DC mode
Please connect SKYRC D260 with AC/DC power supply by supplied DC input cable. Also
you could use terminal clips with DC connectors, for attaching directly to 12V car
batteries. It is critically important that you use either a fully charged 13.8V car battery or a
high-quality AC/DC power supply in the range of 11-18V DC output with minimum power
350W or higher to insure reliable performance.
2). Connecting the battery
Important!!! Before connecting a battery it is absolutely essential to check one last
time that you have set the parameters correctly. If the settings are incorrect, the
battery may be damaged, and could even burst into flames or explode. To avoid
short circuits between the banana plugs, always connect the charge leads to the
charger first, and only then to the battery. Reverse the sequence when
disconnecting the pack.
· 12 D260