Verbatim Napoleon Lighting Series Installation Manual

Napoleon Lighting Series LED Downlights
Installation Guide

Important Safety Instructions

WARNING – RISK OF SERIOUS INJURY AND PROPERTY DAMAGE: Carefully read all instructions and
product labels prior to installation.
• WARNING- Risk of fire or electric shock. The installation, service, and maintenance of this light fixture
must be performed by a licensed electrician. If you are not qualified, contact a licensed electrician.
• Product installation must comply with the National Electrical Code and all local electrical and building
codes and regulations.
• Do NOT install if product is damaged.
• Prior to installation, maintenance, inspection or removal, turn off electrical power at fuse or circuit
breaker box.
• Do NOT use input power other than the voltage specified on the Product Specifications.
• All wiring connections should be capped with UL approved wire connectors.
• Ensure that your installation matches all elements shown in the descriptions and drawings of the
installation instructions before you begin.
• Do NOT make or alter any openings in the housing, enclosure of wiring or electrical components of the
light fixture during installation.
• Do NOT allow the wiring to contact sharp edges, such as sheet metal edges.
• Wear gloves and safety glasses at all times when removing light fixture from carton, installing, servicing,
or performing maintenance.
• Avoid looking directly into light while on.
• Keep combustible and other materials that can burn away from light fixture and lamp/lens.
• Suitable for use in damp locations.
• Ensure that the light fixture operates within an ambient temperature of -4ºF to 104ºF (-20ºC to +40ºC).
• THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
Verbatim 5 year warranty www.verbatimlighting.com/warranty.
For support, visit www.verbatimlighting.com/support
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation.

Product Dimensions

Trims
Part No. Model Number
70663 TR2-WB-RO
70664 TR2-BB-RO
70665 TR2-WG-RO
70666 TR2-WB-RO-EL
70667 TR2-WB-RO-PH
70668 TR2-WB-SQ
70669 TR2-WB-SQ-WW
70670 TR2-DW-RO
70671 TR2-SW-RO
70672 TR2-SB-RO
To lock gimbal settings, tighten screws on side of trim.
Cut-out Hole
3 in.
3 in.
3 in.
3 in.
3 in.
3 in.
3 in.
3.5 in.
3 in.
3 in.